Procedure automation EGV - safety
- Type of vehicle used in zone 10
FMX (FEEDER) MXX (VNA)
-
Positions from the emergency buttons on the vehicles:
FMX
This vehicle is equipped with 5 red Emergency buttons, those buttons could be find on the left, right, front and rear from the vehicle.
MXX
This vehicle is equipped with 4 red Emergency buttons, those buttons could be find on the left, right and in the cockpit from the vehicle.
Obstacle detection (scanners and sensors):
FMX
MXX
- Warning signals from EGV vehicles:
FMX
- ‘Beep’ signal for 2 seconds = the vehicle will start moving
- ‘Beep’ signal for 1 second = there’s a vehicle error, the EGV will stop!
MXX
- ‘Beep’ signal for 2 seconds = the vehicle will start moving
- ‘Beep’ signal, for 1 second = there’s a vehicle error, the EGV will stop!
How to block the EGV?
FMX
To block the automated vehicle use the safety cone, this cone must being placed in the middle from de the drive way from the vehicle.
This means on the left and right side at the front part of the warehouse (zone10)
MXX
To block the automated vehicle use the safety cone, this cone must being placed in the middle from de the drive way from the vehicle.
This means on the left and right side at the front part of the warehouse (zone10)
Blocking from the EGV vehicle at the rear side, put the cone behind the vehicle, in the middle.
WARNING!
The yellow safety mark on the ground is a clamp risk zone! Please do NOT step on it!
Don’t step here!
HELPDESK:
WMS – AUTOMATION 764
EMERGENCY:
ICE 550 (014 742 550)